Barricon!

This is a Barricon (a Barricade with a Recon mag well).  

I got impatient for a stockade so I put some motors from a Power strike 48 in a barricade which should be somewhat comparable. For good measure I put the mag well on cannibalizing the tommycon which was just collecting dust.

 A bit of a write up after the jump.

 A bit of a write up after the jump.

Elite Draw Extention & Spring compression (with recon to retaliator conversion)

These mods will cover how to:

• Remove ARs
• Increase usable volume of the plunger tube
• Preload the spring
• Install the Retaliator internals into a Recon

The power mods have this blaster (Retalicon?) hitting about 75ft flat as long as the darts don't swerve into the ground out of the barrel.  Angled the ranges are over 100ft.

To install Retaliator internals into a Recon shell Very little work needs to be done.  It only needs some of the ribs to be ground down and a plate in the back to hold the spring in while allowing the plunger rod to go through.

Tomicon

I threw this together a while back.  The reason I did this was because the tommy 20  shell fits URB motors perfectly.  URB motors and flywheels are much more powerful than any nerf flywheel system so this thing packs a punch.  At 16v it was getting over 70ft with chopped streamlines.

Oddly enough since most modders don't like flywheels the most useful part of this post for other people might be the tape I leave on the blaster.  When I have blasters that need specific screws to go into specific holes I just unscrew then cover the screw port with tape so everything stays in place till its ready to be put back together.